CitriSafe Room Pak
Includes:
- Dispenser & Botanical Refill
- Mold Solution Concentrate
- Vent Filter Kit
- Bio-balancing Candle
- (2) Safe Room Maintenance Candles
- Agrumax
- Laundry Liquid Concentrate
- Personal Ionic Air-Refresher Unit
- Pharmacist/Environmentalist Specialist Consultation
- Mold Test Kit w/ 4 extra Test Plates
- $50 Coupon towards Lab Test Fees
Furniture, Carpet & Cars Protocol
The gravity plate tests only for the number of mold spores in the air. If you are concerned about a particular piece of furniture, rug, car seat, pillow, sofa, or any textile that cannot go into the washer, you will need to perform a “tap test”.
Wash and dry your hands thoroughly prior to testing. Hold the bottom part of the agar plate so the agar is facing away from your hand. Wrap your fingers around the plate so the tips of your fingers are just over the edge of the face. You want to then tap the item 3 times with your fingers hitting the object (the agar should not touch the object – hit with your fingers). This will force the mold spores into the air and onto the plate. Replace the lid, place a piece of tape on each side of the plate, label the bottom (date, name, object), wrap in tinfoil and put in a warm spot for 3 days; then look at it. Call us if you have any questions. If the plate(s) shows a lot of growth, you should send it overnight to Immunlytics ~ 4301 Masthead NE ~ Albuquerque, NM 87109 ~ 505-217-0339 for identification and count.
This is an inexpensive, do-it-yourself, alternative method to determine the “range” of contamination, not an absolute. Mold inspectors normally charge between $800 and $1,500 for testing. ImmunoLytics charges $45 per test plate analysis for under 4 plates. If you send in 4 or more plates the charge is $175 for 4 plates plus + $30 for each plate over 4, i.e. 6 plates would be $235.00. Discount coupons are available occasionally – be sure to ask.
If Your Carpet is Contaminated by Mold
The carpet must be “surgically” removed. Do NOT drag the carpet pieces through the house. Use the following technique:
- Spray carpet with diluted Mold Solution Concentrate to minimize dust.
- Cut a 1 to 3 square foot section from the carpet.
- Remove the piece and place in a plastic bag.
- Spray the spot where the piece came from.
- Repeat the process with the next piece of carpet.
- Vacuum carpetless area with a HEPA vacuum.
- Spray floor again with diluted Mold Solution Concentrate.
If Your Car is Contaminated by Mold
For ultimate results, have your car fogged with LV14. Maintain your car with Mold Solution as follows:
- Turn your fan on high using the car’s Air Climate Control System.
- Press each button until the vents are sucking air into the car from the outside.
- Pass a tissue over the outside vents next to the windshield.
- Spray a large amount of diluted “Mold Solution Concentrate” on both sides.
- Leave the doors opened and the fan on for 10 minutes.
- Spray the entire inside of the car. Let the inside air-dry.
- Do this 2 times in the first week, then monthly or more often.
- Do a 1-hour self-test on your car with the motor running quarterly or as needed.
- Use the Auto Diffuser with Auto Bio-balancing Emulsion.